- 您现在的位置：买卖IC网 > Sheet目录505 > RXM-GPS-SG-T (Linx Technologies Inc)GPS MODULE SMD SIRF
POWER CONTROL
The SG Series has a built-in power control mode called Adaptive Trickle Power
mode. In this mode, the receiver will power on at full power to acquire and track
TYPICAL APPLICATIONS
Figure 4 shows a circuit using the GPS module with a passive antenna.
VCC
satellites and obtain satellite data. It then powers off the RF stage and only uses
VCC
1
NC
GND
20
its processor stage (CPU) to determine a position fix (which takes about 160mS).
Once the fix is obtained, the receiver goes into a low power standby state. After
a user-defined period of time, the receiver wakes up to track the satellites for a
user-defined period of time, updates its position using the CPU only, and then
resumes standby. The initial acquisition time is variable, depending on whether
it is a cold start or assisted, but a maximum acquisition time is definable. This
cycling of power is ideal for battery-powered applications since it significantly
μ P
RX
TX
GND
GND
2
3
4
5
21
6
7
8
9
10
NC
1PP S
TXA
RXA
GND
GPIO10
LCKIND
GPIO1
RFPWRUP
ON_OFF
RFIN
GND
VOUT
NC
GND
GPIO13
GPIO15
GPIO14
VCC
VBACKUP
19
18
17
16
22
15
14
13
12
11
GND
VCC
reduces the amount of power consumed by the receiver while still providing
similar performance to the full power mode.
GND
GND
In normal conditions, this mode provides a fixed power savings, but under poor
signal conditions, the receiver returns to full power to improve performance. The
receiver sorts the satellites according to signal strength and if the fourth satellite
Figure 4: SG Series Module with a Passive Antenna
Figure 5 shows a circuit using the GPS module with an active antenna.
VCC
is below 26dB-Hz, then the receiver switches to full power. Once the fourth
satellite is above 3 0dB-Hz, the receiver returns to Adaptive Trickle Power mode.
VCC
1
2
3
NC
NC
1PP S
GND
RFIN
GND
20
19
18
For optimum performance, SiRF recommends cycle times of 3 00mS track to 1S
interval or 400mS track to 2S interval. CPU time is about 160mS to compute the
navigation solution and empty the UART. There are some situations in which the
receiver stays in full power mode. These are: to collect periodic ephemeris data,
to collect periodic ionospheric data, to perform RTC convergence, and to
μ P
RX
TX
GND
4
5
21
6
7
8
9
TXA
RXA
GND
GPIO10
LCKIND
GPIO1
RFPWRUP
VOUT
NC
GND
GPIO13
GPIO15
GPIO14
VCC
17
16
22
15
14
13
12
300 Ω
Ferrite Be a d
GND
VCC
improve the navigation result. Depending on states of the power management,
GND
10
ON_OFF
VBACKUP
11
the receiver will be in one of three system states:
GND
Full Power State
All RF and baseband circuitry are fully powered. There is a difference in power
Figure 5: SG Series Module with an Active Antenna
GND
consumption during acquisition mode and tracking mode. Acquisition requires
more processing, so it consumes more power. This is the initial state of the
receiver and it stays in this state until a reliable position solution is achieved.
CPU Only State
This state is entered when the satellite measurements have been collected but
the navigation solution still needs to be computed. The RF and DSP processing
are no longer needed and can be turned off.
Stand-By State
In this state, the RF section is completely powered off and the clock to the
baseband is stopped. About 1mA of current is drawn in this state for the internal
core regulator, RTC and battery-backed RAM. The receiver enters this state
when a position fix has been computed and reported.
The table below shows the RFPWRUP and Vout conditions in each power state.
SLOW START TIME
The most critical factors in start time are current ephemeris data, signal strength,
and sky view. The ephemeris data describes the path of each satellite as they
orbit the earth. This is used to calculate the position of a satellite at a particular
time. This data is only usable for a short period of time, so if it has been more
than a few hours since the last fix or if the location has significantly changed (a
few hundred miles), then the receiver may need to wait for a new ephemeris
transmission before a position can be calculated. The GPS satellites transmit
the ephemeris data every 3 0 seconds. Transmissions with a low signal strength
may not be received correctly or be corrupted by ambient noise. The view of the
sky is important because the more satellites the receiver can see, the faster the
fix and the more accurate the position will be when the fix is obtained.
If the receiver is in a very poor location, such as inside a building, urban canyon,
or dense foliage, then the time to first fix can be slowed. In very poor locations
Power State
Full power
CPU only
Stand by
RFPWRUP
H
H
L
VOUT
Enabled
Enabled
Enabled
with poor signal strength and a limited view of the sky with outdated ephemeris
data, this could be on the order of several minutes. In the worst cases, the
receiver may need to receive almanac data, which describes the health and
course data for every satellite in the constellation. This data is transmitted every
15 minutes. If a lock is taking a long time, try to find a location with a better view
of the sky and fewer obstructions. Once locked, it is easier for the receiver to
Table 2: RFPWRUP and VOUT conditions
Page 8
maintain the position fix.
Page 9
发布紧急采购，3分钟左右您将得到回复。
相关PDF资料
RXM-GPS-SR-T
GPS MODULE SMD SIRF W/ANT
RZE002P02TL
MOSFET P-CH 20V 200MA EMT3
RZF020P01TL
MOSFET P-CH 12V 2A TUMT3
RZF030P01TL
MOSFET P-CH 12V 3A TUMT3
RZM002P02T2L
MOSFET P-CH 20V 0.2A UMT6
RZQ045P01TR
MOSFET P-CH 12V 4.5A TSMT6
RZQ050P01TR
MOSFET P-CH 12V 5A TSMT6
RZR020P01TL
MOSFET P-CH 12V 2A TSMT3
相关代理商/技术参数
RXM-GPS-SR-B
功能描述:GPS模块 GPS Receiver with Integrated Antenna
RoHS:否 制造商:Linx Technologies 频带:1.575 GHz 通道数量:20 首次定位时间（冷启动）:35 s 获取敏感性:- 144 dBm 水平位置精确度:10 m 工作电源电压:3 V to 4.2 V 工作电源电流:46 mA 接口类型:Serial 最大工作温度:+ 85 C 安装风格:SMD/SMT 尺寸:15 mm x 13 mm x 2.2 mm
RXM-GPS-SR-T
功能描述:GPS模块 GPS Receiver with Integrated Antenna
RoHS:否 制造商:Linx Technologies 频带:1.575 GHz 通道数量:20 首次定位时间（冷启动）:35 s 获取敏感性:- 144 dBm 水平位置精确度:10 m 工作电源电压:3 V to 4.2 V 工作电源电流:46 mA 接口类型:Serial 最大工作温度:+ 85 C 安装风格:SMD/SMT 尺寸:15 mm x 13 mm x 2.2 mm
RXM-UHF
制造商:RADIOMETRIX 制造商全称:RADIOMETRIX 功能描述:UHF Radio Telemetry Receiver Module
RXP0005
制造商:Panasonic Industrial Company 功能描述:ARM
RXP0014
制造商:Panasonic Industrial Company 功能描述:PULLEY
RXP0015
制造商:Panasonic Industrial Company 功能描述:ROLLER
RXP0016
制造商:Panasonic Industrial Company 功能描述:ROLLER
RXP0016-4
制造商:Panasonic Industrial Company 功能描述:ROLLER